Playa Vista Windows & Doors, Measured Floor to Ceiling
Tall glass doors, folding walls and new windows for Playa Vista homes, planned from the floor-to-ceiling height that decides how far the glass can climb.
The first number we write down in a Playa Vista house is the height from the finished floor to the underside of the ceiling framing. It tells us whether the glass can run the full height of the room, whether a transom has to sit above a standard door, and where a beam can hide. Width comes second. With the height known, the room can be sketched with its view in mind.
What the height decides
Headroom decides how tall the glass can go. A header has depth, and the depth has to fit in the gap between the glass and the ceiling line. Where the room is lower, a transom pane above the door or a beam recessed into the ceiling can close the gap. Where the ceiling is high, full-height panels become possible, and a taller view comes with them. The floor matters too, since the inside finish and the patio outside should meet at one low threshold.
From numbers to glass
With the height and the width noted, the engineer sizes the header and the posts, and the glass is picked to suit the side of the house the wall is on. On a lot close to the water, damp and wind find a weak seal quickly, so frames and fasteners are picked to resist them and the sill rests on a pan that drains outward. If the lot falls inside the coastal zone, that extra review gets checked early. Tempered panes go wherever the code calls for them.
Windows & Doors in Playa Vista: what people ask
Ceiling height and the roof above both set the number. A wall that carries only a roof can open widely on one beam, while an upper floor, a braced panel or utilities in the wall reduce it. We take the measurements and framing photos, and the engineer confirms the width before any quote is written.
Tall rooms suit tall folding panels, which clear a large gap and stack neatly to one side. Sliders keep the hardware simple, with one fixed panel in the view. Pocketing doors vanish into a deeper wall. Opening height affects which systems are available, so we check the catalog against the measured height.
That beam spans the opening and carries the roof and floor load the studs used to bear. It sits on posts with solid support below. Its depth takes up some headroom, which is why height is measured first. The inspector looks at the framing before drywall.
Windows & Doors in other cities
More of what we build in Playa Vista
Start your project in Playa Vista
Send the form with the size of the space and what you want to change.